Urgent.News

What's breaking now, across hundreds of outlets.

Tech

PETG’s stringing and adhesion problems intimidated me at first, but fixing them only took a few minutes

PETG was well worth the extra effort

PETG’s stringing and adhesion problems intimidated me at first, but fixing them only took a few minutes

When I initially started 3D printing with PETG, I found myself intimidated by its stringing and adhesion issues. To my surprise, these problems turned out to be relatively easy to fix. I initially struggled with the bed temperature being set too low, which caused the first layer to fail and resulted in overall model failure. After adjusting the bed temperature to 80°C, I still encountered minor layer adhesion problems.

To combat this, I reduced the exhaust fan speed to 0% for the initial layers and 10% for the rest of the model. I also lowered the print speeds to 35 mm/s to provide the newly-melted filament with more time to bond with the underlying layers. These adjustments significantly improved layer adhesion for most of my prints. However, I was still confronted with stringing problems, which were largely attributed to the filament absorbing moisture due to its hygroscopic nature.

Given that the humidity levels in my area ranged between 50–65%, I decided to invest in a filament dryer to mitigate this issue. Storing unused PETG spools inside the dryer and sealing the rest of the filaments in bags with desiccant bags helped reduce stringing considerably. Although I haven't entirely eliminated stringing from my models, I now have a heat gun on hand for those occasional strings around the open spaces on my prints.

Despite the initial challenges, PETG has become my go-to filament for functional prints due to its solid impact toughness, temperature resistance, and weather durability. It provides a safer printing experience compared to typical industry-grade filaments while also being relatively affordable.

Rewritten by urgent.news; may contain errors — check the original.

Read the original at xda-developers.com →

Report a problem with this story

More in Tech

More from Saturday 21 November →