FAA halts installation of routers that led to ground stop
WASHINGTON — The Federal Aviation Administration has paused the installation of the routers that were linked to last week’s national ground stop, and turned off any Juniper routers that were already installed. The decision was made after technicians linked Friday’s disruption of key air traffic control systems to one of these routers that had just been installed in El Dorado, Arkansas. For now,…
The Federal Aviation Administration (FAA) has halted the installation of routers that were connected to last week's nationwide ground stop, and has deactivated any Juniper routers that had already been installed. This decision came after technicians traced Friday's disruption of critical air traffic control systems to one of these newly installed routers, located in El Dorado, Arkansas.
Until the root cause of the issues at 17 of the 22 regional air traffic control centers is determined, the FAA is temporarily employing older Cisco routers, which have been in service for 25 years, to maintain network operation. The malfunctioning routers are currently undergoing testing at L3Harris' laboratory, the company responsible for their installation.
In response to the events, senators from both parties are urging a pause in the nationwide replacement of thousands of routers and are demanding that the Trump administration provide a clear explanation of what transpired. The source of the problems has not yet been fully identified.
Written by urgent.news from The Korea Times's reporting — not their text. Machine-written — may contain errors; check the original before relying on it.
Other reports of this story
- FAA halts installation of routers that led to ground stop koreatimes.co.kr
- FAA stops installation of routers it linked to national ground stop pbs.org
- FAA halts router installation following nationwide ground stop abcnews.com
- US senators demand FAA pause upgrades linked to nationwide ground stop aljazeera.com