Urgent.News

What's breaking now, across thousands of outlets.

Tech

D-Link DIR-806A Rev A1 Login - Default Gateway and Credentials

The D-Link DIR-806A Rev A1 is an AC750 dual-band router — 2.4 GHz and 5 GHz in one box — and like most D-Link hardware it hides its settings behind a small web page at a fixed address. If you need to change the Wi-Fi password, check who is connected or update the firmware, the login below is the way in. How to log in to the DIR-806A Rev A1 Connect to the router by Wi-Fi or Ethernet. The factory…

The D-Link DIR-806A Rev A1 is a dual-band AC750 router, combining both 2.4 GHz and 5 GHz frequencies into a single unit. To access its settings, you must navigate to a web page at a preset address. For the 2.4 GHz connection, the network name is DIR-806A, while the 5 GHz network uses the name DIR-806A-5G. Using a browser, input either http://192.168.0.1 or http://dlinkrouter.local to reach the login page.

By default, the username and password are both "admin". Upon first login, you may be prompted to create a new admin password; do so and remember it for future access. Once logged in, you can access the router's main dashboard or run the setup wizard for further customization. The router's page may fail to load if you are not connected to the router directly, so ensure you are on the correct network and check the gateway address in Windows using the ipconfig command.

If the login is rejected, remember that passwords are case-sensitive; double-check that Caps Lock is not engaged. In the event that you have forgotten the admin password, hold the reset button for approximately ten seconds, allow the router to reboot, and then sign in again using the default "admin" credentials. If your DIR-806A model belongs to a different hardware revision, consult the label located on the bottom or back of the device for accurate gateway addresses and default credentials.

Written by urgent.news from Dev.to's reporting — not their text. Machine-written — may contain errors; check the original before relying on it.

Other reports of this story

Every outlet that reported this, and when →

Read the original at dev.to →

More in Tech

OpenBot: How to Run a Team of AI Agents on Your Computer

Why replacing isolated chat windows with a local-first workspace—complete with shared channels, FIFO task queues, anti-jobs, and human circuit breakers—changes the way you build software and run…

  • OpenBot introduces a local workspace for AI agents, replacing isolated chat windows.
  • FIFO queues and collision-free handoffs enable smooth transitions and auditability for AI agents.

Reading car fault codes from a web page: Web Serial and Web Bluetooth vs. cheap ELM327 clones

A cheap ELM327 adapter, Chrome, and two browser APIs are enough to read engine fault codes without installing anything. The protocol part is small; most of the code deals with how real adapters and…

  • Web Serial and Web Bluetooth APIs enable reading car fault codes via web page.
  • Chrome and Edge support these APIs for USB or BLE adapter access.
  • OBD-II layer reads various codes like stored, pending, freeze frame data, sensors, VIN.

More from Tuesday 17 November →