{
  "id": 20721074,
  "title": "Why Seal Surfaces Leak While the Ra Number Looks Fine",
  "url": "https://urgent.news/2026/11/19/why-seal-surfaces-leak-while-the-ra-number-looks-fine",
  "topic": "tech",
  "section": "Tech",
  "published": "2026-11-19T07:58:09.000Z",
  "source": {
    "name": "Dev.to",
    "slug": "dev-to",
    "url": "https://dev.to/chxprecisionmetal/why-seal-surfaces-leak-while-the-ra-number-looks-fine-56k6"
  },
  "original_language": "en",
  "account": "A buyer recently submitted a leak test report, detailing twelve 316L VCR-type glands, all machined from certified bar stock and displaying an Ra value of 0.4 µm. Six of these fittings leaked under helium testing, indicating that Ra alone cannot predict sealing performance. Ra is a measure of average surface roughness, but it does not account for surface geometry such as grooves, lay, or waviness, which can significantly impact seal performance. A fine, uniform tool mark and a surface with a deep spiral scratch can have identical Ra values, but only the spiral scratch will serve as a leak path. Additionally, the lay or direction of surface marks is crucial, as turned surfaces with concentric marks align better with the leak path, while polished surfaces with random lay and fine scratches may perform worse. Waviness, a measure of longer wavelength surface irregularities, is another factor that Ra fails to detect. A gland face that is slightly concave due to waviness can still show a low Ra value while the contact pressure line is misaligned, leading to seal failure, especially in small flange dimensions. In practice, three factors determine the success of a VCR-style joint sealing: flatness of the lands, absence of directional scratches, and an isotropic, fine surface texture that allows the metals to conform under load. Electropolishing can improve surface texture by removing the micro-cracked layer left by machining, but it does not correct geometry issues. The sequence of machining, deburring, measuring, polishing, and re-measuring is essential to ensure that the critical dimensions are within tolerance after polishing. When ordering machined parts with sealing functions, it is important to request additional measurements beyond roughness, such as flatness and leak-based acceptance criteria, and to clarify which features are measured before and after polishing. This information helps ensure that the final product meets the desired sealing performance standards.",
  "summary": "A buyer sent us a leak test report last quarter. Twelve fittings, all VCR-type glands in 316L, all machined from certified bar, all showing Ra 0.4 µm on the inspection sheet. Six of them leaked at helium. The Ra number could not explain it, because Ra was never the problem. This post is about what Ra does not measure, and why metal-to-metal seal surfaces fail in ways that show up only at leak…",
  "key_points": [],
  "editors_take": null,
  "illustration": null,
  "coverage": {
    "outlets": 1,
    "also_reported_by": []
  },
  "ai_generated": true,
  "disclaimer": "Summaries, key points and the editor’s take are written by software from other outlets’ reporting and may contain errors — always check the linked original."
}